Yesterday I was able to sneak out of work a little early so we could get a better start. We were able to get the transmission mounted on the engine, get the transfer-case installed, and we got the shifter installed on the transmission. The pedals were a little tricky to get out of there but we managed. Now we’re waiting for answers. We got ready to install the bracket that holds the t-case shifter linkage and we cannot figure out how it’s installed. We know the parts are there because it was working on the donor, but we assumed that it would be the same on the auto’s setup. It’s not. I have a few picture requests out and have been searching but I haven’t found any pictures of the bracket that we can use for reference. In addition, I found out the linkage itself is different so I’ll have to find a new linkage and new front and rear drive shafts.
